| Subject: | Re: [RESOGUIT-L] Soundwell problems | | Date: | Monday, August 21, 2006 17:13:38 (+0000) | | From: | s.cassadyjr <s.cassadyjr @...net>
|
Neat idea! What is the embroidery hoop made of? What kind of glue did you use?
Was the stiffness of the hoop sufficient to hold it in place until it dried, or
did you clamp it?
-------------- Original message from <Martin3@tampabay.rr.com>: --------------
> Asian resos tend to have a soundwell either off center or the lip is too far
> under the top. I found a solution which seems to work for me.
>
> go to a craft store & buy a embrorary hoop (they come is many sizes, but 10 inch
> is good,) take it apart & use outside hoop, remove hardware & you should only
> have to cut a small bit off to fit inside the soundwell. Glue it inside the
> soundwell flush with the top (of the soundwell) & sand where it is too thick. I
> tried this on a Johnson while installing a Quarterman cone & it made it sound
> better than my Dean (with Quartman) & my 76 Dobro (louder & very clear & sweet)
>
> Bob sin TI
>
> ---------------------------------------------------------------------
> You're subscribed to this list with the email s.cassadyjr@att.net
> To unsubscribe, email resoguit-l-unsubscribe@elistas.com
> For information, visit http://www.eListas.com/list/resoguit-l
> For help(do's n'don'ts) email resoguit-l-help@elistas.com
> For neat stuff go to http://www.resoguit.com
> The ListOwner is poobah@resoguit.com
>
|
Re: [RESOGUIT-L] S
Reply to this message